CAN LAMBDA
€360.00
Link’s CAN Lambda is an easy to use CAN module that provides digital wideband sensor control via CAN bus and is compatible with leading aftermarket ECU’s.
If using the CAN Lambda with a G4+ Plugin ECU use a Link CANPCB cable to access the CAN port on the Plugin PCB and a Link CANF field insertable CAN plug.
Please note proper CAN protocol must be followed.
All prices are exclusive of Irish VAT. VAT is charged at 23% where applicable.
The CAN-Lambda’s ability to measure the proportion of oxygen in exhaust gases makes it an essential tool for accurately tuning fuel mixtures as well as allowing your ECU to make tuning adjustments on the fly.
Being fully digital the CAN Lambda’s powerful LSU 4.9 sensor will eliminate any loss of signal, risk, delays and errors that analogue alternatives cause. The CAN-Lambda never requires free air calibration.
Box contents:
- CAN-Lambda device
- Bosch LSU 4.9 Sensor
- Deutsch 4-way connector kit
- O2 Bung and Plug
- 2 Large Stickers
- 2 Small Stickers
- Quick start guide
Specifications:
1 x 4 pin make DTM connector (power/CAN)
1 x 6 pin mating connector for LSU 4.9 Lambda sensor
Dimensions:
Enclosure 60 x 26 x 15 mm
Lead length 170mm
Weight 70g
Input Voltage:
Controller 7.5 – 20 V
Sensor 10.8 – 16.5 V
Input Current:
Controller 100 mA
Sensor Heater 8 A
Operating Temp – 20 – 100 deg.C
Sensor Bosch LSU 4.9
Sensing Range 0.67 – 10 lambda
CAN Frequency 1MB/s, 500KB/s, 250kb/s, 125kb/s
Related products
"Championship Winning Engine Mapping" Using Dynapack Chassis Dyno.
